GTA01Bv4> help ? - alias for 'help' askenv - get environment variables from stdin autoscr - run script from memory base - print or set address offset bdinfo - print Board Info structure boot - boot default, i.e., run 'bootcmd' bootd - boot default, i.e., run 'bootcmd' bootelf - Boot from an ELF image in memory bootm - boot application image from memory bootp - boot image via network using BootP/TFTP protocol bootvx - Boot vxWorks from an ELF image cmp - memory compare coninfo - print console devices and information cp - memory copy crc32 - checksum calculation dcache - enable or disable data cache dhcp - invoke DHCP client to obtain IP/boot params diskboot- boot from IDE device echo - echo args to console erase - erase FLASH memory exit - exit script fatinfo - print information about filesystem fatload - load binary file from a dos filesystem fatls - list files in a directory (default /) flinfo - print FLASH memory information fsinfo - print information about filesystems fsload - load binary file from a filesystem image go - start application at address 'addr' help - print online help icache - enable or disable instruction cache ide - IDE sub-system iminfo - print header information for application image itest - return true/false on integer compare jerase - erase FLASH memory for JFFS2 katinstall - Load kernel to RAM from offset at top of flash katload - Load kernel to RAM from offset at top of flash loadb - load binary file over serial line (kermit mode) loads - load S-Record file over serial line loady - load binary file over serial line (ymodem mode) loop - infinite loop on address range loopw - infinite write loop on address range ls - list files in a directory (default /) md - memory display mdc - memory display cyclic mm - memory modify (auto-incrementing) mmcinit - init mmc card mtest - simple RAM test mw - memory write (fill) mwc - memory write cyclic nfs - boot image via network using NFS protocol nm - memory modify (constant address) ping - send ICMP ECHO_REQUEST to network host pinit - PCMCIA sub-system printenv- print environment variables protect - enable or disable FLASH write protection rarpboot- boot image via network using RARP/TFTP protocol reset - Perform RESET of the CPU run - run commands in an environment variable saveenv - save environment variables to persistent storage saves - save S-Record file over serial line setenv - set environment variables sleep - delay execution for some time test - minimal test like /bin/sh tftpboot- boot image via network using TFTP protocol version - print monitor version
